Forum
×

Notice

The forum is in read only mode.

VL3 Editor issue with VL3 v1.2.00b175 firmware

Winslow replied the topic: VL3 Editor issue with VL3 v1.2.00b175 firmware

Hi Ian,

thanks for reply. I'll check that and stay tuned for next version.

Cheers

Pascal

idc replied the topic: VL3 Editor issue with VL3 v1.2.00b175 firmware

Hi Pascal,

Version 1.0.1e of the Editor will have limited support for Build 175.
As it's designed or build 161, you will have to make sure that both the midi input and midi output numbers are set to 1, also sysex id must be set to 0, and midi in and out filters must be set to none.
With these settings Version 1.0.1e should detect the vl3 and start to read in the presets.
As the SYSTEM area has changed in build 175; DO NOT use the editor to change any of the System Section. The Editing of presets should still be Fine.

A New version will be released that supports Build 175 when I receive the updated Sysex Documentation from TC-Helicon and incorporate the New Sysex and Additional functions into the Editor.

Ian

Last edit: by idc.

Winslow created the topic: VL3 Editor issue with VL3 v1.2.00b175 firmware

Hi,

VoiceLive 3 Editor (v1.0.1e) doesn't work anymore after updating VL3 unit to official v1.2.00 Build175 firmware. Status 'INITIALIZING' just like when there is no device connected to usb port.
I've checked with VoiceSupport to be sure this is not a usb port issue : the VL3 unit is correctly recognized.

Regards

Pascal

EU e-Privacy Directive