VoiceLive 3 / Extreme FREE Editor 1.4.6

Hi

Do you by any chance have global tempo turned on ?

If you have any globals turned on, the values that are held in the preset data; will immediately get changed when you activate a preset, the editor will then pick this up as a change and inform you the preset has changed ( which it has as the current state of the preset is different to the version held in the preset data when the vl3 was scanned).

If you have global tempo turned on, then any change the editor does to change tempo will be ignored because global tempo is active. Did the Editor give you a notification message when it started up?

For the Editor to work; you will have to make sure that all the midi settings are correct and that you have no NO globals active, also make sure that Global NAT PLAY SOurce is set to off, as this will also trigger preset change messages also, as all other settings are actual settings and will override any values you have set within the presets.

Note if the editor has shown you a notification message; if you click yes to correct the globals issues, when you exit the editor it will return your global values to their state before the editor was started.

Hope that helps

Recently started using VL3 FREE Editor and am generally pleased. However, I routinely experience a couple of frustrating problems.

1. I am prompted to save preset even when nothing has been changed.

2. The guitar delay tempo defaults to display 121 ppm even though it is set at another value. If I change the tempo via the editor or VL3, the editor display value reverts back to 121 ppm.

Any help or suggestion is appreciated.

Hello again,

It installed perfectly, no problems.
Many thanks.

Happy Beagle

Hi Henry,

If the Editor is not installing, could you check you A/V software is allowing the Editor and Installer through, the Editor does not contain any viruses or malware.

All updates to the editor can take up to 10 days to propagate the various Anti Virus databases, also make sure your A/V definitions are kept up to date.

If the Editor is starting to run; but then comes up with an error or freezes; can you post what the error is or even better a screen dump, so that I can investigate further.

Cheers
Ian

Hello,
I have the latest VL3 firmware on my Windows 7 computer and have D/L the new VL3 Free editor software from this site, however it won't install, it just hangs.
Is anyone else having this problem, or is the problem in my computer?
I am currently running the previous VL3 Free editor software with no problems.


Confused
Henry Beagle

This topic is for any issue with version 1.4.6 of the FREE Editor ( support for firmware Build 350)

If you have any issues please keep them in this thread, as it aids in debugging and fixing any issues.